-
The test phantom for evaluation of high contrast resolution of fluoroscopy system in one exposition. It consists of eight patterns of wire mesh in a pie shape. -
This modular phantom made of PMMA consists of several plates allowing variation of phantom thickness setup in steps of 25 mm, up to a total of 300 mm, simulating a range of patient sizes. -
The phantom for evaluation of imaging performance of fluoroscopic systems. It allows brightness and contrast adjustments, circular geometry check (scanning linearity) plus wide-range low-contrast and high-contrast resolution evaluation. -
The phantom for evaluation of imaging performance of radiographic systems. It allows wide-range low-contrast and high-contrast resolution evaluation and sensitometric measurements. -
The Pro-Alpha phantom can be used for carrying out acceptance and constancy tests of conventional radiography X-Ray units.
-
This device readily indicates a 1% or 2% misalignment at a 1 m focal-film distance (FFD), but it can be used at any FFD. It can also be used to check fluoroscopy alignment and collimation.
-
The Pro-AlphaG phantom is a simple tool to check geometry of the R/F system: collimation / beam alignment and position and size of the effective radiation field. -
The radiopaque ruler in the image provides a permanent reference of image size. It can be used to check the accuracy and position of the light field for quality control and adjustment as well as be included during x-ray procedures, leaving a clear measurement right on the x-ray image itself. -
The compact and easy to use phantom for performance evaluation of fluoroscopic systems according to Center for Devices and Radiological Health (CDRH) specifications. It also meets recommendations of AAPM Report No. 60 “Instrumentation Requirements of Diagnostic Radiological Physics”. It is optimized for both under- and over-table fluoroscopic tubes. -
The compact and easy to use phantom designed to invoke a response of automatic-exposure. Follows the Center for Devices and Radiological Health (CDRH) specifications of a chest phantom and AAPM recommendations from Report No. 31 ”Standardized Methods for Measuring Diagnostic X-Ray Exposure”.
-
The edge test device according to IEC 62220-1 for determination of Modulation Transfer Function that consists of a tungsten plate fixed on a lead plate. -
The edge test device according to IEC 62220-1 for determination of Modulation Transfer Function.
